What the hell do i need? to make 800hp+ on my car!

[stealthrt]

-Iridium plugs.
-high flow catalyst converter.
-radiator upgrade is only a inch wider then stock but higher flow.
-I did had selected a fuel spark system i guess i didnt put it
MSD DIS-4 HO High Output Ignition Amplifier
-I haven't decided if to bore out to 3.15l (94mm) and 92mm is the stock size
-goin to run a genII forged crank.
-Stock vr-4 blow off valve has a 30psi limit and i dought i would go over that much boost but if i did..
-Fuel Kit at 3sx store is made of:
high flow fuel filter kit with lines going up to the front fail, fuel rail loop kit from front rail to back rail, and FPR kit with gauge to manage fuel pressure
-actually, its a aluminum crank pulley
and it weights 1 pound 11 ounces stock pulley is around 7 pounds.
- a 14'' brake kit, i would like to be safe, if not that just get slotted rotors.
- plan to use actually full intention is just fast accelaretion from a red light at mid rpm band launch.

-budget if done in two years from now, probally 12k max.

you didn't answer ALOT of my questions, or see any of my concerns with buying things you dont need/want.

12k will not get you past 500hp reliably, and that means doing your own work, which im sorry to say, you dont seem like you could do.

[getto301]

you didn't answer ALOT of my questions, or see any of my concerns with buying things you dont need/want.

12k will not get you past 500hp reliably, and that means doing your own work, which im sorry to say, you dont seem like you could do.

i dont even have to pass that much 400hp is the new goal. i did anwser most of them man...

[stealthrt]

i dont even have to pass that much 400hp is the new goal. i did anwser most of them man...

yea, and you obviously put alot of research into each and every question huh? If you put that much thought into anything you do with your car, it wont last a week.

Iridium plugs, do you even know the difference between these and coppers? what heat range do you plan on running, resisted, or non-resisted?
catalyst converter? it that located next to the flux capacitor? CATALYTIC CONVERTOR
radiator upgrade? an inch WIDER? how would that help? I think you mean THICKER. why do you think you will need these or thin/high flow fans? do you know the efficiency of the stock radiator?
Why do you think the stock coil pack is so bad? where do you find these 10mm MSD wires to go with that ingnition?
really think the stock BOV can handle over 14 psi? sadly mistake if so..

Im not even going to go into the rest of it. good luck?