Quote Originally Posted by Twinturbo6
yeah thats what i need, but 6 of them. And the crank has to be offset ground to the out side so as to make it a stroker set up, then the block has to be bored .20 over and assembled. Nothing to fancy. What would that look like price wise?
pistons would prob be around $600-650 as a set of 4 runs $450.

As far as offset grinding a crank, that is a little tricky. i dont know how much taht would run, ill have to ask Jim

.20 bore, most machine shops charge $100-140 for bore/hone

I charge $700 to assemble and blueprint/balance a Honda motor (that includes assembling the head as i usually have to install valvesprings and cams and valves)

i would have to look and read up on this mazda engine as i have never built one. althoguh and engine is an engine, as long as its not a BMW