Quote Originally Posted by Arm&hammer
im looking to make 250-300 wheel horsepower with a k20a2!
parts:
buddy club spec 3 cams
cp pistons with eagle rods
individual throttle bodies
battle ground k20 swap header
ferrea valves 6000 series
3 angle valve job
skunk2 springs and retainers.
and getting a good shop to putt all that together for me.
and maybe later doing a k24 bottom end with a type-s head and a dc5 tranny.

will the setup be a good setup to reach my goal?
That setup will make 250whp. I would not run the ITBs, i would run an RBC or the IPS manifold if you have the loot.

250whp that header will work, its not the best by any means but it will work.

Pistons i wouldnt run, id get the pistons CHUNKY has , PM him he just made 242whp with a mild setup.