year, make, model and engine code would help.

obd2 single cams are easier than obd1/0 single cams.
b/h series are the same as obd1/o single cams.

96-2000 D series engines have markers on the crank pulley and a sight on the drivers/timing belt side of the motor.

this is the same on all d/h/b series. omce you pull the crank pulley you will see this.



you can also use a long screw driver. remove the spark plug in cylinder1. place a long screw driver in the sprak plug tube. rotate the crank BY HAND until it reaches its highest point. TDC. you may also be able to rely on the Cam gear. it has UP and arrows to show tdc on the top end.
B AND H below


D series


once you remove the head, this is what it should look like if you set it at tdc