You thoughts on a f22 head + f23 block

[dorin48]

rev to about 6.5k

+

I would install basic bolts and some bisi goodies in addition

= No sense.

Rev that bitch.

As long as the oiling is good the bottom end shouldn't complain about higher rpms. I think 7.5k or somewhere near that is totally feasible without the possibility of premature failure of bearings.

[bigdare23]

+



= No sense.

Rev that bitch.

As long as the oiling is good the bottom end shouldn't complain about higher rpms. I think 7.5k or somewhere near that is totally feasible without the possibility of premature failure of bearings.

I was thinking like his stage 1 cams (the power range is good to about 6.5k). Honestly I'm not too worried about high revs. Plus, I shouldn't have to rev it that high with that stroke to make power.