Ok so an update. I pulled both relays off the car (that are on the firewall)....one is all black the other one is black and grey at the borrom (its a little bigger). So since I'm a little green when it comes to using the DMM but i bought the best one I could find and set the DMM to continuity......test both sides of each relay. Not sure what they are supposed to read but I read the instruction manual and it states that if it beeps then that = bad. So the first relay (all black one side reads somewhere around 76-78 this is the side with smaller contacts. The side with the bigger contacts gives no reading and beeps.
The bigger relay gives a 62.7 - 62.8 and beeps and the other side just beeps with no reading. I will try to run 2 wires off the batter to the relays and see what the readings are but does that tell any of you anything.
Just realized based on the FSM I pulled the electric pump relay.....So the one that seemed to fail the continuity test is the fuel pump relay but again I'm not even sure I tested it right.
Reply With Quote