What Does Your Engine Bay Look Like?Post-em

[LIKEG6]

Does anyone sell a mount for the half size or do you just have to make your own?

[slow_hatch]

Does anyone sell a mount for the half size or do you just have to make your own?

No, and it won't fit right without alot of modification. I've got mine where is sits straight up and down right now, but it took alot of work. I'd take some pics, but it is all taken apart right now I'm going w/ an all aluminum unit, i've had shitty experiences with the stupid plastic end tanks.

[LIKEG6]

No, and it won't fit right without alot of modification. I've got mine where is sits straight up and down right now, but it took alot of work. I'd take some pics, but it is all taken apart right now I'm going w/ an all aluminum unit, i've had shitty experiences with the stupid plastic end tanks.

LOL yea right now I have zip ties FTW

Been tryin to figure out how I'm gonna make it work for a little bit I don't have a rad support either so it sucks.


Are the mishimoto and the like the same size as the OE halfsize?

[jmmx258]

No, and it won't fit right without alot of modification. I've got mine where is sits straight up and down right now, but it took alot of work. I'd take some pics, but it is all taken apart right now I'm going w/ an all aluminum unit, i've had shitty experiences with the stupid plastic end tanks.

The only modification I did with mine, was I cut a hole through the skeleton of my hood so when its shut, the cap sits up inside basically.

For the bottom, I laid a piece of rubber down in between the core support, and cross member, and it sits nicely down in. My hood shuts just fine. With my radiator standing straight up.

[slow_hatch]

The only modification I did with mine, was I cut a hole through the skeleton of my hood so when its shut, the cap sits up inside basically.

For the bottom, I laid a piece of rubber down in between the core support, and cross member, and it sits nicely down in. My hood shuts just fine. With my radiator standing straight up.

Hrmm..I am also having to make sure it is far enough forward to clear my shitty DP so that might be my main problem. I need to cut some of my core support, I wonder how much I can cut out I've seen people cut the whole thing out before, but they seemed to be more of drag cars.

[jmmx258]

Hrmm..I am also having to make sure it is far enough forward to clear my shitty DP so that might be my main problem. I need to cut some of my core support, I wonder how much I can cut out I've seen people cut the whole thing out before, but they seemed to be more of drag cars.

I'm assuming your DP exits to the right/passenger side. My snail is on the other way around. I made my own DP and it comes out, wraps down around the snail, and hugs the oil pan with 1/2 clearance between the two. I put a few strands of heat tape on the pan. With just a piece of screen and I cut one of my spare foam air filters for my race bike to use as a filter. I do have room to run a piece of IC pipe and a filter. I just chose not to because I've seen what a dirtbike air filter stops, and its less cluttered this way