Finally got some time to get back to my project. Petit and Seca made for a busy month.

Got the motor ready to go in the car, new timing belt, gaskets and seals, added drain plug to pan. I had to make some things like the drain plug, stud and 2 pivot pins for the manual tensioner since the guy I bought it from didnt include it. All these little things take up so much time in the long run.

Drain plug:


Motor with the Kaizenspeed kit installed and ready to run:


I also think Im ready to cut my driver side 3 hole mount:


This is the 4th different design I have done for it in the past 4 days.
I also finally found some 12x1.25x35 Flat head C'sink bolts and mostly finished my plate. Just have to find a tap now as I have every flavor of 14mm taps except that one. I also made the flywheel spacer, pretty generic so I didnt snap any pics.

That mount, the slave spacer, flywheel bolts, header-mod, and Alt bracket are all I lack.