Well after researching on d-series.org came to a conclusion that i dont need most of the parts in my opening statement to get me to my power goal. So with that said this is what ill be using in my build

p29 pistons 75.5mm should put me in 12.5:1 compression range
bisimoto stage 2 cam and springs
bore block .20 over
milled head .40
get a 3angle valve job
pnp head as well
shot peened rods (stock) lightened to same weight as crank
stock intake mani
stock injectors
and bolts on and get a tune
That should put me in low 13s in a crx!!!!!
d series ftw bitches and wont even cost me that much