na car is only fast in a light weight shell. most turbo honda are slow because they run a turbo that is too laggy. unless you running around with a gutted crx or eg civic, good luck winning.

my friend and i built a b18b 6 years ago. it has .040" over topline gsr pistons. he grinded some material off the bottom of pistons and zero out the weight with a scale.
he also grinded about 2lb off the crank, rods and stock pistons. the whole assemble are balanced afterward at advance machine shop. the head was decked to the service limit mark (about .024"). the block was .018". we got the head welded at a metal fabrication place in hiram, georgia. home ported head. i ported the roof of intake and exhaust port and smooth out the short radius. fidanza aluminum flywheel with some weight machined and drilled out. this included some weight drilled out off the friction surface of the flywheel. 3 pucks ceramic clutch disc made by clutch specialty in marietta for 75 bucks with stock pressure plate. crower cams, valve springs, and retainers. home made 4-1header . safc. dsm 380cc injectors (non turbo 4g63). lighten stock cam gears by drilling some weight off the spokes. hacked and ported stock intake. short ram intake. vp 100 octane. 8 degree advance with the distributor. 265psi compression reading on a mac tool compression tester. we were hoping for 285psi but bs topline rings gap were bigger than we like. the motor had about 15% leak down because of this. he got 215hp on a dynojet with civic si rims and 200hp with konig 17in rims. not too bad for a poor man all motor b series. it was in an integra so it was slow as hell. best 1/8 mile was 8.6s.