93 240sx help
i have a 93 240sx coupe
ok today when i started it up today it just stoped going into gears like it wouldnt go into and really but befor today it shifted awsome the clutch gripped awsome but the throw out bearing was bad and it never grinded wat should i do ?
go have your tranny looked at...cause it sounds like you fucked it up to where it will not let it take pressure of to allow you to change the gears...but the way you made your statment confusses me on exactly what you mean...
You know better; next time will be a ban.
check the clutch fully make sure it is ingageing and does it not go into ger when cars not running ?
more than likely leaking slave cylinder not letting the clutch disengage. check the fluid in the clutch master cylinder to see if it's low and if it is look under the right side of the car on the bellhousing to see the slave itself.
hold the clutch down in neutral, hold the motor at about 3k rpm, and try to put the car into every forward gear.. if you can't, your pressure plate is not releasing.. which means, no pressure (slave cylinder)
You should sell it to me.
haha or me...
You know better; next time will be a ban.
i concur with hipsi, clutch slave most likely
its fixed now and sell what to yall
The carOriginally Posted by santacruz77
- 2011 BMW 535i M-Sport - BMS Stage 1
- 2003 TL-S Totalled
- 2004 TSX - A-Spec wheels
- 1991 S13 RB25DET S2 - sold, and missed
how much you wanna give me for pm if your really want it
what did the problem end up being?
ugh i just put a new clutch and presure plate in and it fixed it all good as new
You know better; next time will be a ban.
ya i kno
maybe it was your clutch slave...............................?
Posting Permissions
Reply With Quote
