◄Need a tool.....!►

[Patterson]

Does anyone have a 21mm Allen? I have a 19 but it's not big enough. it's for my R6 swing arm axle pivot bearing. It's holding me back from droping the bike and removing the engine.

-Ant.

you can use a bolt head. put two nuts on the bolt and lock them together then use a socket or wrench to back it out. hope this helps

[AnthonyF]

you can use a bolt head. put two nuts on the bolt and lock them together then use a socket or wrench to back it out. hope this helps

Fucking awesome. I dont think I have one that size but I will try it out. I found the tool I need on snap-on.com and the Yamaha dealers are closed. Fucking pussies.

+41 for homey.

-Ant.

[Patterson]

Fucking awesome. I dont think I have one that size but I will try it out. I found the tool I need on snap-on.com and the Yamaha dealers are closed. Fucking pussies.

+41 for homey.

-Ant.

ace hardware is where i get mine. i also weld the two nuts together just to make sure they will not back off.

[speedminded]

you can use a bolt head. put two nuts on the bolt and lock them together then use a socket or wrench to back it out. hope this helps

Bingo! There's always more than one way to do something. Any hardware or any parts store will have a bolt with a head size of 21mm to 13/16".