i got it already, im having the code 14 which is the idle control valve. i put a new motor in the car and the new motor came froma 5spd, so i had to change the tranny and wiring harness. but when i got the wiring harness all hooked up everything hooked up fine but the idle contol valve, the old intake manifold had all the sensors on the throttle body, and this one has one of them on the back of the manifold, and its only a 2 wire circle clip, and the old one was a 3 wire rectangle/oval shape clip. i took the clip from the old harness and wired it into the same colored wires leaving the orange one out. it was running fine, any way i can get it to not put out a cel code?