Looks pretty good man! Keep the progress going!








Had binding on the transfer case yoke and rear driveshaft, so I dropped the transfer case to install a slip yoke eliminator (SYE). It does away with the stock tail housing and mainshaft/slip yoke for a fixed yoke to run with a slip driveshaft or cardan joint driveshaft. Luckily I can use a FRONT shaft from the same model Cherokee, so I'll be grabbing one at PAP over the next week or so and then reinstalling everything next weekend if everything goes to plan. I'll probably be replacing the trans mount, cross member with a heavy duty one, the drivers motor mount, and the front rotors while I'm at it! I haven't driven it in about a month at this point so I'm ready to get it going again!