lol, that's not even a comparison between crower and skunk2 pro series. Right now the Skunk2 pro series is the best cam that you can get for what you are looking to do. Talk to vteckidd about getting a skunk2 pro1 cam and valvetrain package. If you run the skunk2 pro cams DO NOT RUN ANY OTHER VALVETRAIN but the skunk2 pro valvetrain. With skunk2pro1's and the rest of the setup you are talking about you will basicallly have the same motor I do. Depending on the header that you run you should be in the 185-190 range with a solid tune. If you have the extra money get a good header. If not then you can pick up a used DC JDM 4-1 header with 2.5" collector for a reasonable amount. I am running a sparks racing header which I expect to pick up a good 8-10 whp and a good bit of torque over the DC because of it's 4-2-1 design. Another advantage my motor will have is a three angle valve job and a little deshrouding done by DFE on my head. It's very easy to get cought up in doing everything at once and get in over your head. Think it out as to what you want to do, set a goal, figure up ALL of the parts you are going to need, make a budget, and get things done either when you get the money together or in stages. Unless you are just a baller and got the dough to spend, which in that case you can go a little bit deeper and make more power!