Gauging interest: 5 lug conversion hubs group buy

[RsonGt3's]

I need an itr hub my rear wheel bearing is noisy as heck where can i find one?

[NoWAyItZTOMmY]

Technically the hub is different, son you can't use itr hubs on ef knuckles.

And yes this is aimed at EF's, but if you want some for your EG, we could make those too.

yea i know the hub is different. i was going by FFsquad diy, where they used da hub and bearing with itr hub. and they machined the hub a bit.

I need an itr hub my rear wheel bearing is noisy as heck where can i find one?

honda, they are about 120? or you can check out 97-01 prelude one.

[Black R]

yea i know the hub is different. i was going by FFsquad diy, where they used da hub and bearing with itr hub. and they machined the hub a bit.
honda, they are about 120? or you can check out 97-01 prelude one.

I meant to say so and not 'son' in my reply to you.

I saw the ffsquad write up, and either the info is wrong or... Idk.

I've measured hubs and bearings of siR/ex vs itr, and it's not .5mm like they posted - it's 5mm.
That's a ton to take off from a load bearing area - especially for a part that could kill you if it fails.

[NAIZBST]

98 1998 Acura Integra Wheel Hub Assembly - Driveshaft & Axle - Beck Arnley, First Equipment Quality, GMB, Koyo, NTN, National, PartsMaster, Pronto, SKF, Timken, Rear - PartsGeek

I need an itr hub my rear wheel bearing is noisy as heck where can i find one?