need help!!
i just changed my front wheel bearing and my axle but when i drive the car and is pressing brake to slow down i hear a sound (squeaky noise), so i checked my brake pads and rotors, and they seems to be fine but still making the noise, idk whats wrong with it. can it be the ball joints that is making the noise? should i just go head and change the brake pads? will an alignment stop the noise? or is the noise coming from the new wheel bearing?
please help ia... the squeaky noise is very annoying
try general tech
CD5 Accord
Check the brake shield its more than likely touching the caliper/rotor
i did and its clear.Originally Posted by -EnVus-
is it making the noise the whole time the car is being driven or just when your pressing the brake? if it squeaks when you turn it might be the ball joint, b/c mine would squeak when i turn and then the lower ball joint fell out and messed my fender all up. maybe when you had the brake pads off you stepped on it getting something pressed in the brake pad so now it squeaks when you hit the brakes haha
can it be the upper ball joint then? cause my look kind of loose, or it looks like it's gonna pop out
well if the rubber grommet, or boot or whatever the tech. term is is busted. i would change it. bc it can get dirt, sand, or water in there and causes rust/wear down and cause it to pop out when you hit a bump or turn. if you have your car slammed out you might want to look into the extended ball joints; buddy club, m-factory, spoon, few more i think. but some of them have grease fittings in the that allows you to grease them for a longer life
can it be the caliper too? maybe the caliper went bad or is weakin?
Posting Permissions
Reply With Quote