My mild street build

[Init2winit]

Yeah, gonna have the valves done too.....haven't decided between 3 or 5 angle job though, other than that I've kinda ran my budget past what it was suppose to be. The plan at first was sending them off to Advance Induction to have them CNC ported, but my casting are a little thinner than most LT1 heads and flow a little better, then I was gonna send them to L.Elliott to have them ported......all this fell through and my kids b-days rolled around (a week apart) so funds went down hill there. They are gasket matched and have a "little" bit of porting to them (friends basement).

I would think about investing in a valve job at least, since the heads are already off. As far as CnC porting, don't waste your money on that with those heads. If you know of someone that can actually do a 5 angle valve job, do that. I can also recommend someone that is very reasonable on prices with that stuff.

[Slomaro Z28]

I would think about investing in a valve job at least, since the heads are already off. As far as CnC porting, don't waste your money on that with those heads. If you know of someone that can actually do a 5 angle valve job, do that. I can also recommend someone that is very reasonable on prices with that stuff.

I'm not sure if he can do it or not.(Tommy Goza, my dad grew up using him and he knows the family somewhat)

[slostang]

I'm not sure if he can do it or not.(Tommy Goza, my dad grew up using him and he knows the family somewhat)

damn I haven't herd that name in years! does tommy still have that blue studebaker?

[Slomaro Z28]

damn I haven't herd that name in years! does tommy still have that blue studebaker?

not sure all I ever see is an ole red f-250

[slostang]

not sure all I ever see is an ole red f-250

the studebaker is his drag car.