UPS Came with Bisimoto goodies!!!

[Riceboy891]

Well the itbs themselves were $60 off ebay, manifold was free. I cut and prepared it and had it welded at N Ga Speed Shop in woodstock for like 200. Velocity stacks were used from a porsche dealer in marietta for $30, and I am making the weber stack adaptors~like $5-10. Vacuum manifold was made from a air tool distribution block from northern $5-10. So th ITBs total cost =just over 300 dollars. Motor was just over 400 from japanese engine of atlanta in marietta. Cam, gear, and springs were, 500. So probably a little over 12-1300 dollars pieced together over a few years. Anyways if I come out putting down stockish B16 numbers I will be totally happy. A cammed and ITB'd SOHC is way sicker than a stock B16 like everybody else. By the way here is a pic of the ITB's and my new wheels.

[A-TL]

Very nice, good luck with the build.

[GSRteg®]

GL SOHC FTW

[CBEeng.]

Well the itbs themselves were $60 off ebay, manifold was free. I cut and prepared it and had it welded at N Ga Speed Shop in woodstock for like 200. Velocity stacks were used from a porsche dealer in marietta for $30, and I am making the weber stack adaptors~like $5-10. Vacuum manifold was made from a air tool distribution block from northern $5-10. So th ITBs total cost =just over 300 dollars. Motor was just over 400 from japanese engine of atlanta in marietta. Cam, gear, and springs were, 500. So probably a little over 12-1300 dollars pieced together over a few years. Anyways if I come out putting down stockish B16 numbers I will be totally happy. A cammed and ITB'd SOHC is way sicker than a stock B16 like everybody else. By the way here is a pic of the ITB's and my new wheels.

FRIGGIN LOVE IT im thinking about going a similar route

[TheChosenOne]

I was just thinking about this, but you should slap a vtec head on that thang!