bump

VENOM PRODUCTS

Venom 400, Performance Control Module




The VENOM 400™ is only active when peak performance is required. During normal driving the VENOM 400™ remains passive until the microcomputer determines that engine airflow and throttle position warrants increased performance. Normal fuel
economy prevails while under normal load.

Enhances the performance gains achieved by installing an upgraded chip. Whatever the gains are as specified within the chip, they will be magnified through the use of the VENOM 400™.

The VENOM 400™ has an off switch so smog certification is achieved when not racing.

The VENOM 400™ will not trigger the emission safeguards of today’s vehicles.

Easy installation in 20 - 30 minutes with basic hand tools requiring only four electrical connections.

Red cockpit LED indicating VENOM 400™ activation.
Up to 25% or more increase in horsepower throughout the power range of 1,000 to 5,000 rpms (where the
vehicles red line is 6,000 rpm).

The flat spot or delay found with automatic transmission downshifts, which can be as much as three seconds, is eliminated. When equipped with auto instead of manual.

VENOM 400 Performance Module

Gain up to 25% more horsepower throughout your vehicle’s low & midrange with the addition of the VENOM 400 Performance Module.


•Fast & Easy Installation
•Noticeable Gains
•Convenient On/Off Switch
•No ECU Reprogramming Required
•Does not Require Hi-Octane Gas
•Easily Removed for Vehicle Service

How it works
The VENOM 400 Performance Module easily plugs into the throttle position sensor (TPS) and the mass air flow sensor (MAF) or manifold absolute pressure sensor (MAP). The VENOM Module takes readings from the output signals from these two vehicle sensors and makes adjustments to optimize the fuel and timing curve of the engine throughout the low and midrange of the power curve.

The end result is a noticeable power increase.

Compared to Chip or Programmer
Unlike a performance chip replacement or a programmer, the VENOM 400 Performance Module can be quickly removed for emissions testing and/or warranty service. The unit does not leave an electronic “footprint” within the vehicle’s computer (ECU). An electronic “footprint” is a permanent recording that occurs within a vehicle’s computer (ECU) anytime the ECU is updated, programmed or electronically altered. Car dealerships regularly void normally covered warranty service on vehicles where ECU tampering has been detected. Voiding of OE warranties forces many car owners to pay expensive bills for valid warranty work.

The VENOM 400 does not directly alter the ECU. Therefore, if the unit is removed from the vehicle its past presence on the vehicle cannot be detected. Once, easily removed, the vehicle immediately returns to stock form.

Also, unlike chips & programmers, the VENOM 400 Performance Module has a convenient on/off switch that allows the driver to activate and deactivate the module. Most chip upgrades are permanent changes, and programmers will generally require the user to plug the programmer back into the vehicle’s wiring harness and follow a series of steps to return the vehicle back to its stock settings – possibly losing or corrupting the stock programming.