WTB: B-series motor ASSEMBLED

[EvasiveEF9]

Still entertaining

[cceinc]

I am posting this for my buddy
these pictures were taken when i was building it.. the
head is still off the block.. it needs a headgasket
and timing belt.. other than that.. its straight..
block was hot tanked and painted. cylinders were
honed.. pistons were polished. rods were shotpeened
and balanced.. so was the crank.. new piston rings..
water pump.. oil pump. rear main seal. new main/rod
bearings.. thrust washers. its really clean as you can
see in the pics. the head was also cleaned.. i have
the cams/camgears.. camcaps and all of that. and i
have an intake manifold.

i also have an A1 cable tranny for b series.

oh yeah.. i have a SRP High Compression pistons on
Eagle Rods too.. 11:5:1 cr.. comes with Wiseco Rings
and ARP Rod Bolts