WTB: OBD0 To OBD1 ECU conversion harness, AND (CPS) for Dohc ZC

[Black4DrEK]

GOT IT!

Please delete

[Black4DrEK]

NEED A CYLINDER POSITION SENSOR FOR DOHC ZC

[BigDsGTP]

I hope I am right on this, but if you are going to OBD1 with a ZC DOHC, you do not need a cylinder position sensor. You will need a TD-43U dizzy though.

to run the engine as OBD1, you will need a OBD0 to OBD1 ECU conversion jumper harness along with the OBD1 ECU and OBD1 distributor, TD43U - the factory OBD1 DOHC ZC ECU is a P29 - you can use a P06 ECU, but it won't work very well - you can chip the P06 ECU to run the P29 fuel and ignition maps - if you use the P06 ECU, you will need to use a 4-wire O2 sensor - the P29 ECU uses a 1-wire O2 sensor - again, you would need to swap out the OBD1 injectors for OBD0 injectors or you can use the OBD1 injectors by removing the injector resistor box from the system - you would need to swap connectors at the distributor or purchase a distributor jumper

from JLICRX at D-Series.org

Good luck. If you do need a cps, I have two, $25 each.

[Black4DrEK]

On the Dizzy there are 2 extra wires i need to splice with the cylinder postion sensor... Im think i can just wire those together, but maybe the car wont run correctly... i dunno lol

[StarBwoy]

bump for ya

[Black4DrEK]

All i need is the jumper harness!


bump.

[southside]

I got one but I was trying to find a guy that was selling the engine harness ecu and dizzy I was going to buy that and sell mines but I cant find him for shit if you can Ill sell you mine.

[Black4DrEK]

Delete