If he calls u out he will def show up. He will only call out someone he is pretty certain he will beat.
If he calls u out he will def show up. He will only call out someone he is pretty certain he will beat.
He might could in the camaro with spray from what I here but if it is just a bolt on gto it wont happen, not from a roll anyway imo. I think it would be a good roll race with me and the camaro if he did not spray, just from what i've heard about it. It's suppost to be around 11.4 in the 1/4th right? on motor.
You don't know very much about my car to say that ^.
(SRT EQUIPPED) It's Just A Neon...
1/4mile= 11.21 @ 127mph 2.0 60ft
The Boost Is Strong With This One.
If You Can't Say Anything Nice,
"Then Go F**k Yourself"!!!
2006 Corvette Z06
2" Stainless Works LT Headers
Random Technologies 3" X-pipe, with high flow polished cats
Callaway "Honker" cold air intake
Ported throttle body and intake
Custom dyno tune by MTI Racing Atlanta
496rwhp/478tq
(SRT EQUIPPED) It's Just A Neon...
1/4mile= 11.21 @ 127mph 2.0 60ft
The Boost Is Strong With This One.
If You Can't Say Anything Nice,
"Then Go F**k Yourself"!!!
That's about what I trap in the 1/8, but I am usually a lower ET. I typically run a 7.8 - 7.9 in the 1/8 at 98mph, then do 11.6 - 11.8 in the 1/4 at 126mph.
I am guessing you would be faster than me from a roll, because if my ET is lower that means I'm probably getting better traction than you. And if I'm getting better traction, but we're trapping the same....then you are probably faster than me (accelerating at WOT for less time), even if I could get a better ET at the 1/4.
2006 Corvette Z06
2" Stainless Works LT Headers
Random Technologies 3" X-pipe, with high flow polished cats
Callaway "Honker" cold air intake
Ported throttle body and intake
Custom dyno tune by MTI Racing Atlanta
496rwhp/478tq