Results 1 to 17 of 17

Thread: jumpy Idle

  1. 10-02-2006, 06:51 PM #1
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default jumpy Idle

    i have a bad idle. it starts to jump from 900-2000 every time im at a red light and its not only annoying but a waste of gas. my CEl is also one but its and off and on thing. ive talk to alot of ppl about the problem and even took it to Oz to fix it but it still isnt straight. Alot of ppl told me it could be ether my iacv or my vacuum line i was wondering if anyone would be able to help me or vouch for someone thanks


    Reply With Quote Reply With Quote
  2. 10-02-2006, 07:09 PM #2
    SLow_POke
    SLow_POke is offline
    Senior Member SLow_POke's Avatar
    Join Date
    Jun 2006
    Location
    WEST_SIDE
    Age
    43
    Posts
    1,841
    Rep Power
    19

    Default

    seen that its all the time not jsut at cold starts up ot eliminates the fitv.

    is you checked all you vac lines i would run a scan since u mention getting a MIL

    btw. what kind of engine, years, car?





    -Ernie
    Reply With Quote Reply With Quote
  3. 10-02-2006, 08:14 PM #3
    Mr_S13®
    Mr_S13® is offline
    IA Juinor Member Mr_S13®'s Avatar
    Join Date
    Mar 2005
    Location
    Cumming, Ga
    Age
    40
    Posts
    493
    Rep Power
    0

    Default

    Up under your throttle body is a little gold plate with 2 screws...take the plate off and there will be a little hub with 2 slots on each side. take a small screwdriver and spin the hub until it touches base with the spring. this should fix your problem!

    If not, then it could be vacuum related so check all your vacuum lines and listen really close around your intake manifold, and throttle body. If either one of those gaskets are bad then that would also cause it.
    [SIGPIC]
    Reply With Quote Reply With Quote
  4. 10-02-2006, 08:36 PM #4
    o_bomb
    o_bomb is offline
    Banned
    Join Date
    Jul 2006
    Location
    ATL
    Age
    42
    Posts
    654
    Rep Power
    0

    Default

    vac lines, maybe tps!?
    Reply With Quote Reply With Quote
  5. 10-02-2006, 10:23 PM #5
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    i have an h22 in a 94 accord


    Reply With Quote Reply With Quote
  6. 10-02-2006, 10:24 PM #6
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    would it be better for me to clean the iacv or just buy a new one? i dont want this problem to occure so i want the best solution


    Reply With Quote Reply With Quote
  7. 10-03-2006, 02:23 PM #7
    civicduty
    civicduty is offline
    too many projects
    Join Date
    Sep 2006
    Location
    Greensboro, NC
    Age
    46
    Posts
    123
    Rep Power
    18

    Default

    buy a new ivac, cleaning it doesnt always take care of the problem and can cause dirt to back up in the them. we have bought them new from honda and had to exchange it becasue it was bad from the start. G/L but thats your idle bug.
    11 camry se
    99 cbr 900rr on n2o
    97 accord h22 on 25psi
    06 scion xb
    01 expedition
    Reply With Quote Reply With Quote
  8. 10-03-2006, 08:50 PM #8
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    how much would it be new from honda?


    Reply With Quote Reply With Quote
  9. 10-04-2006, 08:03 PM #9
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    ok i changed the iacv today and still got the same problem any further advice?


    Reply With Quote Reply With Quote
  10. 10-04-2006, 08:13 PM #10
    allmotoronly
    allmotoronly is offline
    Level IIIa? LOL. allmotoronly's Avatar
    Join Date
    Apr 2006
    Location
    Macon
    Posts
    3,186
    Rep Power
    23

    Default

    Quote Originally Posted by an0therh22
    i have an h22 in a 94 accord
    accords and preludes are imfamous for having FITV and IACV problems. First, on the side of the throttle body there is a brass colored plate. remove the plate. There is valve inside. turn the white plastic piece clockwise until it stops. If that does not fix it, then remove your IACV (front center of IM) and clean the screens out. check to see if it is sticking if possible. If it STILL has a problem (other than vaccum lines which you should have checked first) then it may be one of the gaskets, either the IM gasket, or one of the two secondary runner block off plate gaskets. Also check the O-Rings on the injectors. I also had a problem with a few of my H22A's breaking IM studs, which will eventually cause a vaccum leak. The EGR valve gasket can also blow out (although rare).
    Last edited by allmotoronly; 10-04-2006 at 09:07 PM.
    Land Rover LR3 HSE
    Reply With Quote Reply With Quote
  11. 10-04-2006, 08:35 PM #11
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    my motor is throwing ERG so i have no idea what causing the problem. i just got the iacv changed today and i had Oz look at all the lines so im thinkin it wouldnt be that ether.


    Reply With Quote Reply With Quote
  12. 10-04-2006, 08:47 PM #12
    13Bracer
    13Bracer is offline
    Senior Member 13Bracer's Avatar
    Join Date
    Sep 2006
    Location
    flowery branch
    Age
    36
    Posts
    4,580
    Rep Power
    24

    Default

    Quote Originally Posted by allmotoronly
    accords are imfamous for having FITV and IACV problems. First, on the side of the throttle body there is a brass colored plate. remove the plate. There is valve inside. turn the white plastic piece clockwise until it stops. If that does not fix it, then remove your IACV (front center of IM) and clean the screens out. check to see if it is sticking if possible. If it STILL has a problem (other than vaccum lines which you should have checked first) then it may be one of the gaskets, either the IM gasket, or one of the two secondary runner block off plate gaskets. Also check the O-Rings on the injectors. I also had a problem with a few of my H22A's breaking IM studs, which will eventually cause a vaccum leak. The EGR valve gasket can also blow out (although rare).
    try that i have an h22 lude and after i put my pulley kit on i had the same problem i just adjusted my idle control valve and it stopped

    NIKON D90 | Sigma 10-20mm | 18-105mm | 50mm 1.8 | SB-600 speedlightNIKON Squad
    Reply With Quote Reply With Quote
  13. 10-04-2006, 08:50 PM #13
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    yea we think its the IM gasket but not shure i was just wondering what everyone else thought about this dam hondas and there bad idle i think mine is the worst ive seen cuz ive tried adjusting the idler control valve but it still didnt work i even retarded my dizzie than adjusted it but still the same problem


    Reply With Quote Reply With Quote
  14. 10-04-2006, 08:55 PM #14
    13Bracer
    13Bracer is offline
    Senior Member 13Bracer's Avatar
    Join Date
    Sep 2006
    Location
    flowery branch
    Age
    36
    Posts
    4,580
    Rep Power
    24

    Default

    damn that sucks yeah mine was bad my check engine light came on and startin stallin for no damn reason and shit!!! damn hondas!!!!! so many problems!! but when there good there good!!! good luck with it man

    NIKON D90 | Sigma 10-20mm | 18-105mm | 50mm 1.8 | SB-600 speedlightNIKON Squad
    Reply With Quote Reply With Quote
  15. 10-04-2006, 10:16 PM #15
    allmotoronly
    allmotoronly is offline
    Level IIIa? LOL. allmotoronly's Avatar
    Join Date
    Apr 2006
    Location
    Macon
    Posts
    3,186
    Rep Power
    23

    Default

    don't adjust the distributor... that has nothing to do with a jumpy idle. It is a vaccum leak of some sort. When the FITV or IACV sticks, it lets too much air in and the engine revs higher. One time my IACV fell off and my car idled at 4200rpm... all from a hole that is about 5/8" around... I ducktaped something over it ( i think it was a quarter, i cant remember) so I could make it home.

    Hey when you are driving down the road and you let off the gas, does it decellerate hard? Sometimes the butterflies in the IM will stick. If the bushings in them wear out they will get stuck. It happened to me once. The bushings are nylon, and somehow they deteriorated and the butterfly got stuck open, which makes it run like shit at low RPM...
    Land Rover LR3 HSE
    Reply With Quote Reply With Quote
  16. 10-05-2006, 06:44 PM #16
    an0therh22
    an0therh22 is offline
    h series
    Join Date
    Jun 2006
    Location
    norcross
    Posts
    1,968
    Rep Power
    19

    Default

    Quote Originally Posted by allmotoronly
    Hey when you are driving down the road and you let off the gas, does it decellerate hard? Sometimes the butterflies in the IM will stick. If the bushings in them wear out they will get stuck. It happened to me once. The bushings are nylon, and somehow they deteriorated and the butterfly got stuck open, which makes it run like shit at low RPM...
    yep thats exactly what happens i dont understand this whole butterfly thing so can u clearify it?


    Reply With Quote Reply With Quote
  17. 10-06-2006, 07:33 PM #17
    Z U L8R
    Z U L8R is offline
    Super Dave Z U L8R's Avatar
    Join Date
    Jun 2006
    Location
    Roswell
    Age
    42
    Posts
    1,217
    Rep Power
    19

    Default

    check coolant temperature sensor ( 2 wire for the computer not the 1 wire SENDING UNIT that's for the guage )
    Reply With Quote Reply With Quote
« Weapon R Intake | Symptoms of a blown motor? »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

About us
ImportAtlanta is a community of gearheads and car enthusiasts. It does not matter what kind of car or bike you drive, IA is an open community for any gearhead. Whether you're looking for advice on a performance build or posting your wheels for sale, you're welcome here!
Announcement
Welcome back to ImportAtlanta. We are currently undergoing many changes, so please report any issues you encounter with the site using the 'Contact Us' button below. Thank you!