Custom GSR Throttle Bracket
--did this today. It needed to be done. It'll work for now. I'm hoping to get better gas mileage compared to the rig I had before.
Made from a piece of aluminum I had laying around and as you can see cx oem bracket. --and using the cx throttle cable.
Just wanted to share. Thoughts? Anyone else done something similar?
looks good man....as long as it works
94 Supra= 500rwhp
lol...show ya right:::
YEAH.... LOOKZ LIKE IT WORKZ FINE? YA GIVE IT A TEST RUN FOR A MIN. YET??? GOOD JOB!
^^^yea, response is a lot better. I think I'm going to have to tinker with the rotor spring, though cause sometimes the throttle stays open a little bit--meaning it doesn't go back down to normal idle.
oh i bet....tendz to stick a little bit huh?.... i had that problem wit my GSR TB after JG bored it over.... i had to work with the spring a little... but turned out really well worth it!
as long as it works, its good to go.
speaking of which, I have a skunk2 manifold with a gsr throttle body, do I have to change the damn throttle body to a B16 so I can use the p73 bracket and throttle cable? been tryin to do this for a minute now.
wow...
thats exactly what i used to have b4 i got a custom one from some website that no longer exists.
nice work though
try to cut it and make it nice a smooth for an oem look. Nice job though!
The Carbon Fibered R6
nicely done mang
BUY MY MERCEDES! 2002 ML320 FOR SALE!
Thanks, guys.
Exactly what I was going to do--make it more shapely and round off the corners. I had to make quick work of it temporarily since it's my DD.Originally Posted by TRYMY4.0
Posting Permissions
Reply With Quote
