My motor is finally going to be sent out this week to the engine shop I am soo excited! The build time is 6-8weeks. but here is just a little of what all is going to be done to it.

1 set of VMS connecting rods
1 set of ross pistons 8.2 to 1 compression ratio
1 Fully machined crankshaft
1 set of chrome moly performance rings
1 set of performance rod bearings
1 set of performance main bearings
1 new oil pump
1 new water pump
1 timing belt
1 complete set of cryo treated valve springs
1 fully ported and polish performance cylinder head
1 set of ARP head studs,nuts and washers
We do all of the machining such as boring,honing,balancing the rotating
assembly,adjust valve timing for optimal performance,check and resureface
deck of engine block and cylinder head. pressure test cylinder head.