For purchasing information, please contact me on here through PM, or Text me at 404-416-8192.

I have a KA-T kit. Its running custom manifold, that is T3 flange. The setup was originally made for Rb20DET turbo to be put on the KA, but it can also run the RB25 set up as well. It made 230whp and 265wtq at 13lbs boost on a Dynojet. The setup is as follows: RB20DET turbo (13lb wastegate) SR20 370cc Injectors, Z32 MAF sensor, CX Racing intercooler kit, ARC Blow off valve, 2.5 inch Downpipe. Nistune engine management (Type 3 board, tuned by Scottie at Mainstream Performance) and a Spec Stage 2 Clutch (Used for ~20 minutes of driving including dyno time. Spec says this specific clutch will hold 380ft lbs. torque) Kit goes for more, but Im very impatient and want this crap out of my garage! $1000 firm! Pics below. Also, I plan on parting it out if it doesnt sell, therefore, I listed all the individual parts for sale as well!!!!!





Dyno Vid:
http://www.youtube.com/watch?v=74kTlVqyYok

Driftin'
http://www.youtube.com/watch?v=DR5277jV7PA







CX Racing Intercooler core with couplers and ARC 1st gen BOV! Blow off valve is mounted to intercooler with studs and gasket, the silicone was added to make sure of no boost leaks. Blow off valve is RFL loud with the 25 turbo on it. Only selling because I bought a new motor and it has all this stuff on it already! ($250.)


Z32 Maf with pigtail and Spectre 3" Filter. ($90)


Nistune Type 3 board with KA-T Tune (set up is written on outside) You can wipe it clean and have it reflashed. ($250)


KA24DE Engine Harness wired for Z32 maf ($50)


KA24DE Transmission. Shifts like gravy. Have a new one on my SR, and already have a spare, so no need for this. ($75)


RB25DET Turbo. No shaft play, great condition. Clocked for the KA-T kit I had it on, but can easily be adjusted back. Comes with 11lb and 9lb wastegates. ($200)



RB20DET Turbo. No shaft play, oil residue from blown rings in motor, other than that its groovy. Got it from a member on here, forgot his name. But it boosted fine when I had it on. ($100)



CX Racing Intercooler piping. Powder Coated black. Will fit both KA and SR on cold side, and most Top Mount turbo setups on either motor. ($50)


RB 20/25 Top mount KA-T set up downpipe. Looks kinda choppy but it gets the job done! O2 sensor is KA and flange is setup for S chassis. Better as a package deal obviously, but hey, its your cup of tea. ($50)