B20 BUILD UPDATE! NEW PICS! "OPERATION HYDROLOCK"

[SRDFTITAN]

Hello everyone, I own a 2001 Acura Integra GSR. Here recently I hydrolocked the engine, and am currently in the process of building a b20 vtec turbo combination. Hopefully I'll be done with the engine by the end of the week, break in and slap on the boost. It was kind of a sad event (my engine hydrolocking, only had 60,000 miles on it). But I guess its forcing me to go in and make some power. I've posted pictures of my car. I've also posted pictures of my GSR motor after it was disassembled (NWS) hide the children, that shit was like a horror movie. And I've also included one pic of the B20 block. I'll have more pics maybe tomorrow after assembly.

Thanks,

Ken......open for comments.

OK JUST CHECK OUT MY PHOTO ALBUM FOR NEW PICS!!!!
http://photobucket.com/albums/b268/SRDFTITAN/


I'm getting more pictures very soon but heres a basic list of everything that was purchased for OPERATION HYDROLOCK!!
Head:
GSR head w/ fresh mill ( port and polish)
Dual valve springs
NEXTGEAR thermal intake manifold gasket
JG Edelbrock intake manifold
550cc injectors
BDL fuel rail
Aeromotive fpr
Type R throttle body
Everything was port matched to each other.
2 New cam seals
New valve cover gasket set
New valve stem seals
New valve guides
Valves re-seated
All valves adjusted and head inspected for optimal operation.

Block:
B20B block with fresh hone and deck.
Eagle rods
JE pistons
BDL Block guard
New Type R oil pump
New Timing belt
New Water pump
B20 Head gasket
New crank seal
New rear main seal
New oil pan gasket
B20/VTEC oil line kit
Fresh bearings, rods, mains, and thrust.

Also little misc. parts:
Walbro 255lph fuel pump
Greddy E-01 boost controller
Apexi turbo timer
Exedy stage 3 clutch (3 puck sprung)
Centerforce 7lb flywheel
MSD Digital Plus ignition
Blaster coil
MSD Cap
Crane cams plug wires
All new KYB adjustable shocks
Rear lower tie bar
Rear upper tie bar
Rear c-pillar bar
Rear Triangular bar
Rear 22mm sway bar
Front upper tie bar
And all new Willwood Brakes 11.75" rotor 4 piston caliper.
And last but now least Apexi N1 muffler (turbo), going to run 3" piping ounce I find a decent turbo kit!!!

All I need:
TURBO KIT......
FUEL MANAGEMENT........

I will have more pictures up by Thursday or Friday, but my car should be up and running before Friday!!!!

thanks,

SRDFTITAN

[#1Beaver]

nice

[TeeJay]

nice man, cant wait for the pics!!