Want a Tune, but Can't make it there....

[suthernbred]

just finished my shave/tuck/turbo install on my gsr turbo eg. Now my fuel pump isn't priming! checked all grounds, main relay clicks(went out and bought a new from honda) , checked all my fuses. Im wanting to get it tuned by ya'll @ mainstream..i was referred by Mike from Endless C.C.
(out of Augusta) I'm in Street Innovationz!

Its always something small and stupid with honda's......i ran a jumper from the main relay and was able to prime the fuel pump, checked the power leaving and coming to the main relay,fuel pump,all 3 grounds, under hood fuse box, coil on dizzy, injectors, map sensor, resistor box,and all had power! triple checked all my fuses, and rotated between 2 p28 ecu's! NOTHING!! new spark plugs, im just baffled!!

im goin to use a wire brush today and clean out the 2 grounds into the frame(because the bay was painted...maybe its not grounding properly...reason why fuel pump will not prime!)

Up for advice..thanx!

[yomomspimp06]

just run the jumper.....*runs*
worked on my FC

[suthernbred]

still nothing, can't run a jumper because it forces fuel and sprays gas all over the place with no where to go!

[EmminoDaGreat]

I am sure it is something to do with the wiring, just retrace things you have done. Its hard to diagnose something I can't see. Especially when it is heavily modified.

[suthernbred]

i figured it out, the 3 bar grounded out. but i just called and left a message to try and make an appt for sat. morning so...just waiting for a response. i'll be coming from augusta for hin/nopi.
thanks

[EmminoDaGreat]

cool