Originally Posted by jdm_rs2000
just try it. i've had more customers come to me w/ bad skunk2 conversion harnesses right out of the box. it's the only thing they don't do well. i've seen 3 bad ones this past month from 3 customers that had them. all of them were brand new. last week i had a cust w/ one he pulled from the box and installed. upon cranking the car it had an iacv code. ran the normal diagnostic for iacv. went to the harness and saw the iacv wire had pushed from the plug. pushed it back in...a few min later it was throwing map. decided to look at harness and sure enough, the wire had come loose from the pin. it's getting to the point that if someone comes to me and has a cel and a skunk2 harness i start looking at that first and 90% of the time it's the harness.
the only reason i suggest replacing the harness is that i've seen so many of the skunk2 bad out of the box and go bad because pins pull out and wires come loose of the pins. just find a buddy that has a boomslang or something better than the skunk2 or jdmshit to try out. if your problem goes away then you know what to purchase. if it's still there, then you didn't waste $ and chase your tail and you know to try a new dist.
Reply With Quote