Well its a somewhat straight forward question, either you know the answer or you dont.
The question itself is hard to explain so here goes.
Ok first of all... I've done very little research on this, just brainstorming a ghetto-rigging I might do.
Ok so injectors, they dont have polarities... The prongs inside doesnt matter which one recieves the voltage and which one grounds, same end effect. The voltage is taken from a fused connection to the battery (+12V). Right...
The part that plug into the computer is the ground...This part gets a little grey for me.
So the computer pulsates the ground, completing the curcuit, making the injector operate right...
Ok now say I wanted to add another injector randomly (starion = 2 injector setup)
Hypothetically, say i welded a spot in a hardpipe for the injector to be... etc... and wanted this to operate without megasquirt, standalone, etc.
If i connected the +12V to one prong of the new injector and spliced the ground to the ground of the other injector. Would these two injectors operate exactly the same? Or would these injectors both not operate.
Hypothetically this seems like it'd work.
The only thing that I can think of that would make it not work would be the amount of ground. -5.5V (for example)
Perhaps the grounding mechanism of the computer is too complex and any higher load would cause failure? Anyways anyone know anything about this situation? Its not something that i can just try and check, simply because its involving fuel.
Thanks
Oh yeah if ur not gonna post anything constructive dont post... i know its ghetto rigging but shit fuck you LOLOL
Injector question
Reply With Quote