clutch not engaging...

[3kgtdrvr]

there should be a bleeder screw on the clutch slave cylinder and u just have to pump the pedal and hold it and then losen the screw and then tighten it and then let off the pedal and pump it again and repeat over and over and over until all the air is out....but its VERY important to keep an eye on the resevior so u dont run out of fluid in it bc then u have to start all over again

[THEONE]

it takes 2 people to do this, one to pump and build pressure then hold the pedal to the floor and slowly release the bleeder valve and watch the air bubbles come out do it until there the clutch feels nice to you and only fluid comes out the bleeder screw.just pump and repeat...hmmm sounds dirty.