lol, our race cars have over $1,000 in suspension in EACH corner...I would understand if you were wanting to corner balance it but you're just leveling. Since you said you can put them on i'm assuming you have a reliable floor jack, it's a pain in the ass to continuesly raise and lower but counting threads on the coil-over is a good start...just do one corner to get the desired height then count the threads making the rest the same. NOTE: It will not be level, but it's a good start. From there you'll have to measure, either with a yardstick from the ground to the highest point of the wheel opening of the fender OR from the lip of the wheel straight up to the fender. Note: Most cars will have a little less wheel gap in the rear to make it level so you'll still need a way to measure from the fender to the ground.Originally Posted by LeX
or do that for $75-90 p/hour. I'll do it at my shop for $50 and a beer for a roommate if he helps
Reply With Quote