I have a dent and need it pulled

[SRK420a]

I was wondering if anybody knew a company that could pull this dent out of my passenger rear quarter panel. and could I get an estimate on how much to fix it. Please don't put the most expensive company in ATL

[Arm&hammer]

just put a lot of bondo over it. jk, pull it out yourself. it would be a lot cheaper.

[gsrteg]

use a dent puller (the suction cup puller aint gonna cut it, use the drill in screw type or welder pin type puller) . OR If you can access the quarter panel from the inside of your car, then use a rubber mallet with a wooden block on the other side, and lightly hammer it out as much as you can from the inside, carefully not to thin out the metal or damage it worst... Afterwards, grind the area around dent with air grinder, use body filler (aka: Bondo, or Evercoat Glaze(fiberglass)) to fill up the uneven dent. Use 60-80 grit sand paper break down as much material off, then sand down with 180 and 220, and primer....if you afraid to do yourself, then go ahead and pay a bodyshop...

[nevertolow]

garys bodyshop on covington highway. i used to work there. and everything they do is perfect. just tellem mike mitchell sent you antheyll hook u up cheap. iit looks like a lil hole in the wall place but theyve been on the cover of a sh*t ton of magizines.. i can get u theyre number and address tom. just pm me and remind me

[lanning]

pm grimm reeper and see if he can help you out

[jcs]

i 2nd that post he does good shit just depends on how bad the dent is ,send him a pm

[SRK420a]

took both of you guys advice so we will see what happens thanks

[SRK420a]

use a dent puller (the suction cup puller aint gonna cut it, use the drill in screw type or welder pin type puller) . OR If you can access the quarter panel from the inside of your car, then use a rubber mallet with a wooden block on the other side, and lightly hammer it out as much as you can from the inside, carefully not to thin out the metal or damage it worst... Afterwards, grind the area around dent with air grinder, use body filler (aka: Bondo, or Evercoat Glaze(fiberglass)) to fill up the uneven dent. Use 60-80 grit sand paper break down as much material off, then sand down with 180 and 220, and primer....if you afraid to do yourself, then go ahead and pay a bodyshop...

I used to work at a bodyshop so I know how to fix it but I dont have the tools or the time toyota keeps me busy lol

[Barefoot]

pm grimm reeper and see if he can help you out

i 2nd or 3rd the motion.

[Grimm Reeper]

PM replied and thanx guys