MOTOR MOUNT INSERTS for 96-00 civic---->any tips?

[BB1_luda Jr.]

im doing this for a friend and i was wanting to know if anyone has done this yet and if is there any hints or tips that can make the job done faster....im going to be using 2 jacks....and this is for the rear motor mount that is mostly used in B and d-series only difference is the bracket u use.

1. should i just take out the 1 bolt holding the mount to the rear bracket and just jack the motor up until i got enough clearence to slide the inserts in

2. take out the 1 bolt holding the mount to the rear bracket and plus take out the 3 bolts holding the actual mount to the subframe, pretty much taking out the mount than re-installing the mount.

[imprtguy_94]

well im not a expert on motors. but number 2 sounds like the better option. i dont think you want to move the block around to much.

[BB1_luda Jr.]

thanks i just wanna do it faster.....someone on here had to take this rear mount out before? anyone?

[punkr6]

I personally prefer to remove the rear bracket completely and get it out of the way...

[Barefoot]

I personally prefer to remove the rear bracket completely and get it out of the way...

x2

[dallasb84]

unbolt tranny torque mount.... 3 bolts. leave it off

unbolt top tranny mount,,,, leave it unbolted.

then remove the long bolt in the t bracket mount....


jack motor up so you can reach the bushing from the drivers side working under the intake manifold.....

bolt all 3 back together..... then do all drivers side....


my two pennys