haha still working on getting those on?! if you got a good battery charged, or plugin drill and a good metal drill bit, the whole drilling new holes for the clips takes no time. as long as you take time and do it right it works good.

- old side skirt to side of car with the back lined up, mark everything hanging over the front, cut it off.

- put clips in all the holders on the side skirt

- push whichever ones will line up in, whichever ones dont go into one of the holes push the slide skirts against the car and slide it up and down so it make a line.

- after do that to all the clips, take a drill bit the barely fits in one of the sqaure holes but has a lil room to move

- drill a circle at the right level at each line

- put the side skirt on

after all that, either make new holes in the side skirt for the bottom screws to go into the stock holes on frame, or make new holes in frame for screws to go into stock holes on side skirt.

isnt as much works as it looks, maybe i got lucky and it was easy.




edit: oh yah, you asked a question haha, i got mine froma coupe, im not sure if its easier for new style hatch sideskirts, to go on the older style. this is what i had to do, to get new style coupe side skirts, onto the older style. (except for the cutting) im sure its close to the same for hatch to hatch