How to remove tranny

[k20ej8]

any1 have a diy or any tips on how to remove b series tranny? Im switching mine for an ls. Info and pics would be good

[VickNotic]

pretty simple
7 17mm bolts
2 19mm off the rear T bracket
2 14m off starter
2 12mm bolt off the slave cylinder
disconnect the reverse harness
disconnect the vss harness
2 jack stands (use it to hold the longblock)
1 jack (use it to balance the tranny up & down 8D take off pass mount,

and then bammm

[Barefoot]

nothing special its pretty straight forward.

[NOCLUE]

any1 have a diy or any tips on how to remove b series tranny? Im switching mine for an ls. Info and pics would be good

y switch to an ls what do u have now, and since your switching it might be better to just pull the motor out with the tranny more working room it you
got the right equipment.

[Barefoot]

and since your switching it might be better to just pull the motor out with the tranny more working room it you

not really a honda tranny is so unbelievably easy to R&R its not even funny.

[NOCLUE]

not really a honda tranny is so unbelievably easy to R&R its not even funny.

this is true

[k20ej8]

y switch to an ls what do u have now, and since your switching it might be better to just pull the motor out with the tranny more working room it you
got the right equipment.

itr tranny. going boost

[Tech5]

I do these in 20 mins start to taking it out and about the same going back.. I spend more time cleaning the new tranny and painting then doing the work...But hey that is why I get the big bucks



BTW someone forgot to tell you to disconnect the shift linkage, and take out the axles !

And the dust shield,and engine bracket from motor to tranny supports

And what about the ground?

[Grimm Reeper]

I do these in 20 mins start to taking it out and about the same going back.. I spend more time cleaning the new tranny and painting then doing the work...But hey that is why I get the big bucks



BTW someone forgot to tell you to disconnect the shift linkage, and take out the axles !

And the dust shield,and engine bracket from motor to tranny supports

And what about the ground?

and to also drain out the tranny fluid

[VickNotic]

I do these in 20 mins start to taking it out and about the same going back.. I spend more time cleaning the new tranny and painting then doing the work...But hey that is why I get the big bucks



BTW someone forgot to tell you to disconnect the shift linkage, and take out the axles !

And the dust shield,and engine bracket from motor to tranny supports

And what about the ground?

I"m sorry bout that, i did 4get to tell'm to disconnect the shift linkage and knock out that one lockk tooth watever it's called 8D .. you never seem to dissappoint me Tech 8D

[punkr6]

why are you switching to a ( long geared/garbage ) LS tranny ?

[k20ej8]

why are you switching to a ( long geared/garbage ) LS tranny ?

boost

[punkr6]

boost

hella boost I hope...

[k20ej8]

why would i want to use a short geard, ill spin out in almost every gear

[punkr6]

whats your set up now ?

[gerardojdm]

I suggest upgrading the clutch too while you are at it. G/L

[k20ej8]

thanks alot everyone. that shit was a BIIIIIITCH!!!

[VickNotic]

my response deserves a rep m8 holla 8D

[Tech5]

^ Why you left out key infomation my friend!