ALL YOU NEED IS A SMALL TORCH LIKE THE ONES THEY SELL AT WALMART
1.FIRST HAVE THE DASH OUT......
2. SLIDE A KNIFE UNDER THE VIN PLATE
3. NOW HERE COMES THE TORCH USE A OLD SCREW DRIVER PREFERABLY A PHILLIPS NOW HEAT THE TIP OF THE SCREW DRIVER WITH THE TORCH TILL ITS STARTING TO GET RED..
4. AS SOON AS ITS RED TOUCH THE TOP OF THE STUD WITH THE SCREWDRIVER THAT HOLDS THE VIN IN PLACE AND IT SHOULD WARM IT UP AND NOW USE THE KNIFE TO PULL UP ON THE PLATE AND IT WILL SLIDE RIGHT OUT
5. REPEAT ONE MORE TIME ON THE OTHER SIDE....AND YOUR DONE...

THE GOOD THING ABOUT THIS IT WONT MESS ANY THING UP....AND WHEN YOU INSTALL IT ON THE OTHER DASH JUST PUSH IT IN WITH YOUR THUMB AND IT POP RIGHT IN AND WONT FALL OUT