remove wrist pins from pistons

[BTEC]

take it to a machine shop it cost like 5 bux per piston/rod set.

X2. i dnt trust the socket and hammer thing bc u run the risk of possly bending the rod.

[jmmx258]

You'll only bend the rod if you hold the rod by the bottom while you drive the pins out.

If you rest the piston on a pipe, or a deep well socket, you will not bend the rod because you are applying force in the same area rather than on the rod shaft.

I built and balanced my motor myself. I checked my rods on a marble table, with mics after removing my pistons. They were still straight. There's really no force required to put the pins back in if you do it the same way I did.