Quote Originally Posted by Tech5
What I do is drain with the 3/8 ratchet bolt and take the 17mm bolt out up top , screw the 3/8 bolt back in tighten it, and then take the 1 10mm bolt out of the speed sensor wingle it back an forth an remove it, fill the fluid until it runs out of the 17mm hole then install the 17mm bolt and gentle install the speed sensor and line up the hole and install the 10mm bolt and your done, whip off fluid and clean up your done!

Fluid I use either, Honda/Acura fluid which cost 5.49 qt
or GM syncro mesh!!!