Starting Troubleshoot (HELP!!)

[D.Choe]

Hmmmm weird.

I would take every ground wire off, sand the connection and where it's connected and bolt them back down.

If it was the main relay I don't think it'd run. Does it turn over, click, anything when you try to start? Do you have to push the clutch in to start it?

I'll probably do that tonight, but first I need some sand paper lol

I will get a vid to show you what happens when I try to start, but there's no clicking, no turn over, just whirring and yes I have to push the clutch in to start.

[Truegiant]

have you added any new grounds? I had a bad thermostat housing ground and it caused the same problem. i bought some 2 gauge wire at the parts store and made all new grounds for my engine. and when that later failed i just spliced into the starter signal wire under the dash from the ignition switch to the hot wire input on the starter. worked fine since.