HID/headlight issues.... WTF....

[Doppelgänger]

So lately, one of my headlights will randomly flicker and then turn off. I had a spare [new] ballast so i tossed it in. All was fine for a few weeks and now it's happening again....soemtimes with both headlights, but moreso with the pass. side. Here is where things get a little strange. The ballasts are still getting power just fine, and tapping/moving/tinkering with the wiring and ballasts does NOT yield any results. But, if i turn the headlights off for a moment and turn them back on, then the lights come back on just fine. Now sometimes the light will ficker within 5 seconds and turn off, sometimes it'll take 5 minutes to act up or it won't do it again at all.

I cleaned up the ground off the relay but to no avail, i checked ALL of the wiring and couldn't find a single issue.

Anyone have any ideas? New ballasts?

Hey Nitro......

[phuoc_dat]

change the fuse. WOrks fine for me after i changed the fuse for that headlight.

[Doppelgänger]

change the fuse. WOrks fine for me after i changed the fuse for that headlight.

Now that was just funny!

[blackshine007]

It's possible that you could have a short in one of your connectors to the light has a short or the ballast is going out. Push and twist on all of the wires going into any connector. I was having the same problem when I first got my HID's. I was about to take back the ballast but once I seen that the connector was making a hot spot where it wanted to connect to the light, I pushed the wire in good and tight and haven't had a problem from it since.

[yungdz]

Dude, I could have gave you some headlight fluid at the shoot.

[Doppelgänger]

speaking of... have you seen any of the pics?

/thread jack

[Nitro]

It's possible that you could have a short in one of your connectors to the light has a short or the ballast is going out. Push and twist on all of the wires going into any connector. I was having the same problem when I first got my HID's. I was about to take back the ballast but once I seen that the connector was making a hot spot where it wanted to connect to the light, I pushed the wire in good and tight and haven't had a problem from it since.

^^^^good point!!!


Mike u may need a relay kit or resistor put on your set-up tho i have had it happen with a couple of customer cars......something like this will cure it.

http://cgi.ebay.com/ebaymotors/V-HID...mZ250267991226

[Doppelgänger]

^^^^good point!!!


Mike u may need a relay kit or resistor put on your set-up tho i have had it happen with a couple of customer cars......something like this will cure it.

http://cgi.ebay.com/ebaymotors/V-HID...mZ250267991226

I'll look into the resistor because the kit does indeed have a relay setup already. But what i don't get is it was fine for months (since i bought it in Jan and this only started about a month ago).

[Nitro]

I'll look into the resistor because the kit does indeed have a relay setup already. But what i don't get is it was fine for months (since i bought it in Jan and this only started about a month ago).

what brand kit is it?

[Doppelgänger]

The box that i have says Gech and that it's Japanese made.

[Brett]

Do what I did, Get a car with Factory HIDs and you have no issues

[Tech5]

^^^^good point!!!


Mike u may need a relay kit or resistor put on your set-up tho i have had it happen with a couple of customer cars......something like this will cure it.

http://cgi.ebay.com/ebaymotors/V-HID...mZ250267991226

[AnthonyF]

I had to run relays on my Headlights and foglights for my mustang. Sucked ass. You can change the fuse out for a slightly larger one, but the wires might not be able to handle the power increase.

-Ant.

[Uptown401]

it happen to me with my HID kit, passenger side while driving on road, if my car was to feel a slight bump on road or a lil drop while driving passenger side would flicker and turn off, so i bought a new ballast and replaced it now its working fine.

[Doppelgänger]

Do what I did, Get a car with Factory HIDs and you have no issues

What? A slow ass honda?

[Doppelgänger]

I had to run relays on my Headlights and foglights for my mustang. Sucked ass. You can change the fuse out for a slightly larger one, but the wires might not be able to handle the power increase.

-Ant.

Im already running a relay. Though going up 5 amps on the fuse might not hurt... might install one and see if it still flickers or not. As for th eresistor... im still thinking about it.

But what i don't get is that when i did replace one of the balasts the problem went away completely and came back. So if adding a resistor is what it needs, then why would everything have worked fine after replacing the ballast for awhile? Argh.

[Nitro]

What? A slow ass honda?