if you know you can tighten it, just trim the bolt to where it will fit in there, just dont tighten it as much because it will be more likely to rip the threads out the block. OR, i dont see it causing any problems ide ask around though. just extend the hole in the oil pan that the bolt goes in to the left about 1/4 of an inch, so it turns into more of a slot, then you can put the whole bolt through without it hitting the plug then slide it over and tighten it. if your lucky it will just be a nut that goes on there, will be easier, but either way i dont see tightening it be easy at all.