I shaved the door handle ,and where the plastic trim was( on front and back door and on the fenders) the door is completely flat , but what i meant was in the sanding process the door is just weird i wasnt sure what it was but if i run my hand straight down there is a dip i cant get rid of. for the handle i used "bondo" metal patches on the inside and outside( you have to hammer the edges in around the hole where the handle used to be to allow the patch to sink in a little {if that makes sense}) then use fiberglass resin to fill the hole . to make it strong enough i used it inside and out. any confusion just ask. its a process i did twice because the first time i used regular body filler but it cracks with time.