UNshaving door handles

[Mr. Clean]

depends on if your car still has the lock motor still attached and working so that way you can lock your car when u have handles again.
shouldnt b that hard..just use 36grit paper on an angle grinder until you get to the welded plate,it should b only tacked into place since it beling aluminum.when i welded my plate i could only stay on it for bout 10secs before it burning through.so u prolly can just hammer it out from theback.lol

then get it repainted and put bondo back on if needed to get it smooth again around the handle.cuz welding it tended to dent my metal around it so i needed alot of bondo.

Good luck with that! those poles and locking stuff is a pain!lol

yeah its all mechanical stuff, no electronics so i just have to get the rods and such. i dont really know how to remove all the popper stuff, i havent really even looked.

my driverside door wouldnt unlock itself when i tried to get in it about an hour ago so i am done... i DO NOT want them anymore. if i get all the stuff out, i will freakin give it either to dirty octopus cause it was his car or post a thread about all the stuff and give that shiznit away, its the devil.

[1NonlyAccord]

PMd

[Mr. Clean]

ill send you a PM about it..i dont want people reading bout no locks on a car or sumthn.haha

sounds good