FS 2x Db104 in box with 1000w Amp

[Dominic49]

2x DB104 in custom sealed box (dado cut with internal support.... super strong box.... use it as a jackstand to hold up your car.......)
Driver Complement
Woofer 1 - 10" Diameter (25.40cm)
Dynamic Balance Polymer Composite dish cone
Electrical
Overall Frequency Response 28-200
Nominal Impedance 4 ohms
Power Handling (continuous) 270 w
Power Handling (peak) 540 w
Efficiency 86 dB
Voice Coil Diameter: Driver 2" (5.08cm)
Driver Mounting Depth
Top Mount 5-1/2" (13.97cm)
Bottom Mount 6-1/4" (15.88cm)
Cut-out
Driver Cut-out Diameter 9-1/16" (23.02cm)
Theile/Small Parameters
Recommended Enclosure Sealed / Ported / Bandpass
Resonant Frequency 37 Hz
Qms 7.0
Qes 0.62
Qts 0.57
Vas 0.85 cu. ft. / 24.0 L
Sd 54.25 sq. in. / 350 sq. cm.
Xmax (linear) 0.3 inch / 7.5 mm
Xmax (mechanical) 1.0 inch / 25.4 mm
Le 1.85 mH

1x AP1000M

Power, control, and a great price. You'll get all of that with Profile's AP1000M mono subwoofer amp. It's a great choice when you're looking to bring on the bass — it'll deliver 310 teeth-rattling watts at 4 ohms, with a jaw-dropping 500 watts of power coming your way at 2 ohms.

The level of control is amazing for an amp in this price range. It starts with a handy remote-mount bass control — mount the control in a convenient spot (16.4 foot cable included) and you can adjust the level of bass output right from your driver's seat! Read more

Details:
» 310 watts RMS x 1 at 4 ohms (500 watts RMS x 1 at 2 ohms)
» MOSFET power supply
» remote-mount level control
» selectable bass boost (0-12 dB) at 45 Hz
» variable low-pass filter (50-250 Hz, 12 dB/octave)
» subsonic filter (20-50 Hz, 12 dB/octave)
» preamp and speaker-level inputs
» fuse rating: 25A x 2
» 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
» 13-5/8"W x 2"H x 10-1/4"D
» warranty: 3 years



subs and Amp have 20hours on them and were properlly broken in.... I built the box for SQL and you will not be dissapointed....

PRICE $350 obo