And a complette accord 88 model with an a20 and a manual trans with oem meshes from accords of the time, not ls meshes but very close, good tires. complete car minus dizzy. row 4 at the same pull a part.
And a complette accord 88 model with an a20 and a manual trans with oem meshes from accords of the time, not ls meshes but very close, good tires. complete car minus dizzy. row 4 at the same pull a part.
Here is the come-a-long that i have used. along side the power pole installed by Ga power...
Here are the alignment pics. from beginning to end. you will see in the final pic that the lights are still recessed from the impact. the hood latch just barely latches being that the core support is recessed too far back. the alignment on the passenger light and blinker is a little low.
And last the hood fully closed
Rehung the exhaust for the moment with the hanger wire. it will get properly welded with the new exhaust. yes i will need a complete new exhaust. it has a length hole on the 90 degree that goes from the center to the passenger side.
Lastly, installed the radiator. and intake, it is still taped. ran a breather hose from the intake to the valve cover, just like oem. im looking to replace a few of the hoses with some of the high density stuff that is more attractive.
Last edited by xero_xero; 05-28-2010 at 10:30 PM. Reason: duplicate pics in post.
Posting Permissions
Reply With Quote
