Since I can't get any help from the EG guys...

[bigdare23]

Can you Muther EF-ers get me some measurements on springs?

Measurements on stock, unmolested springs.
Measurements on any brand aftermarket lowering springs.

I need these measurements to be from uninstalled springs.

Also, mainly, are EF springs interchangeable with EG, meaning can you put EG springs in your strut perches?

Thanks. Later, QD.

Sorry homie, but the only set of stock springs I have to measure are on my hatch now.

As for ef springs vs. eg springs. eg springs are much taller. I tried to test fit a set of aftermarket eg springs on the rear of my crx and it raised my car up. So yeah, they will fit (atleast in the rear), but they are tall as hell compared to ef's.

[southside]

Sorry homie, but the only set of stock springs I have to measure are on my hatch now.

As for ef springs vs. eg springs. eg springs are much taller. I tried to test fit a set of aftermarket eg springs on the rear of my crx and it raised my car up. So yeah, they will fit (atleast in the rear), but they are tall as hell compared to ef's.

I seen a guy get some Eibach springs from Nopi and once they were installed on his eg hatch it seemed to sit higher than it did stock

[StraightSix]

I seen a guy get some Eibach springs from Nopi and once they were installed on his eg hatch it seemed to sit higher than it did stock

That's not really that surprising. I didn't know until several months ago that our cars need to have the suspension loaded when tightening all the suspension bolts. If the suspension isn't loaded then the rubber in all the bushings essentially sets a pre-load on the suspension and the car won't sit right.