i finally got both axles out, so i went out tonight and got the passenger side done tonight. here is how it sits with the wheel turned straight. its not too bad. looks like ill be able to straighten it out with just an alignment. ill have a 4x100 lug pattern on the front for now.

this is a stock bg strut on ebay springs, no sleeves.







im probably going to have to put a spacer between the tie rod ball joint and the spindle. it will not get tight enough to keep the tie rod from moving before the actual spindle and wheel turns.



the hub swap on this side actually wasnt that hard. the bottom two holes that bolt the spindle to the control arm are slightly off between bf and bg. i just took a decent sized drill bit and widened it up.

next, driver side.