My K20a2 EG build up thread - TONS of pics!

[Fuster_Cluck]

He was referring to this. ...........................^^^^^^^^^^^

Oh my bad

Yeah, the 93 was white w/ a GSR swap. Sold it back in 2003. The VX is a 95 which is why I'm ready to change my name

[Fuster_Cluck]

Session 047 Part 2 of 2:

Modifying the K20a2 engine harness:

There is a lot of clips to remove from the harness:



First remove the large white one:



Just unclip it:



Slit the rubber grommet:



Comes off like so:



There are 3 of the little green plastic clips that you can remove:





Pry using a flat tip screwdriver to open each one up to remove:



Removed:



How I routed the engine harness to the cabin. That is the heater coolant opening at the firewall. The hole has NOT been modified:



Looking at the same hole from the cabin:



D series harness:



Wire #1 -- Plug "B" (green/yellow wire) - A7



Cut the wires like so &
Wire #2 -- Plug "B" (green/orange wire) - A13



Wire #3 -- Plug "D" (green/red) - D10



If you unwrapped the engine harness you have this fuster_cluck:



Pull the wires you just cut back through so you have length to work with:



Oxygen Sensor wiring......

The 4 wires on the conversion harness:



Strip the plastic to expose some wire:



I don't have the opposite plug to mate with the O2 so I cut the harness off the new sensor. I screwed up by cutting all the four wires even. It's been said the 2 black wires are both grounds so not a big deal to get them mixed up. But, if you have to cut the wires......cut them at different lengths



Hybrid Racing Harness --------- Primary Oxygen Sensor
Green ------------------------- White
Red --------------------------- Light Green or Blue if you have the Denso sensor
White ------------------------- Black
Black -------------------------- Black

Cosmetic caps that really make a difference:



Put them just about everywhere including the studs of the roll bar:



Everything was torqued down and torque stripe added for easy visual check ups:



Clutch line install. Not sure if the teflon tape was needed or not



Thanks for looking